PxPixel
Efficient with Power and Space for Sigur Rós, d&b D8Os Might Reshape Your Next Project - AvNetwork.com

Efficient with Power and Space for Sigur Rós, d&b D8Os Might Reshape Your Next Project

Author:
Publish date:

OAs a culmination of two years of touring the world, Icelandic band Sigur Rós completed the last leg with the latest addition to Skan PA’s equipment roster. Always a company that likes to take the empirical approach to new technology, Skan has been running the slide rule over its new D80 amplifiers from d&b audiotechnik.

Image placeholder title

"We took a d&b system out for Sigur Rós late last year,” explained Skan's system designer for the tour, Tom Tunney. On this short run, which Tunney said spanned perhaps three weeks, the system was based on J-Series with some Q-Series for fill, with D80s driving the whole PA. "The most immediate thing we noticed was an indirect benefit of the active power correction, when we applied the 'pull' on the service with no gain reduction anywhere on the signal path it just sounded clearer. The power saving was also significant; with a full arena system of 60 J-TOPs, 16 per side for mains, 14 per side for side-system, with 16 J-SUBs run off D12, we would normally see a draw of around 60A per phase; with the D80 we were seeing around 20A. I'd taken out a full Powerlock mains distro and the truth was I could have run the whole PA, a modest arena system don't forget, off a 32A three phase CEE Form distro. And there's another thing, we saw a big reduction of current down the neutral; where normally we'd see the sum of the three phases, this was more like it was balanced to the draw from just one leg."

Packaging is another significant criteria for Skan, noted Tunney. "We always look at space saving, at four channels in a 2RU module each D80 basically gains you 4RU of space compared to the four channels of the D12. We have already redesigned our racks to accommodate this benefit. Adding the line gain from losing the d&b SenseDrive return wire to each cabinet, means we can now run 16 boxes off two of our Socapex speaker cables. Naturally there's a truck space gain as well, and it's not as marginal as you might imagine—Sigur took four single racks a side. That wouldn't have even filled half of one of our large-scale touring carts. So downstream we will be rethinking them as well. It was a challenge to convert all our Socapex feeds to NLT4 in time for the Sigur tour, but it works quite nicely. For the SUBs it's very tidy, we just run an NLT8 to a pod of two J-SUBs with a splitter to two NLT4s. It's a seamless upgrade for us really, ArrayCalc to R1 to D80, three steps, and you're all set up and ready to go."

Related

Image placeholder title

Are Powered Loudspeakers Right for Your Next Project?

The lure of simplicity is hard to deny. As powered loudspeakers bring networking capabilities and a reduced reliance on equipment racks — along with ever-important cost savings—integrators are beginning to accept the advantages the category offers, while learning to work around its perceived cons.

Image placeholder title

d&b ArrayCalc V7

Products from the d&b White and Black ranges will be on display, along with two stations on the booth where the d&b new ArrayCalc V7 acoustic modeling software will be shown along with a functioning R1/R70 remote system control setup.